![]() Putting a jumper on to these pins allows the Intel Management Tools to fully read the BIOS, but the Intel Flash Programming Tool (fpt.exe) is not able to write back to it, and displays the message: C:\Intel ME System Tools v8 r3\Flash Programming Tool\Windows64>fptw64.exe -bios -f nvme.bin The HP 8300 motherboard has a similar function called FDO (Flash Descriptor Override): On the Dell OptiPlex 7010 I was able to put the machine into service mode and gain full read and write access to the BIOS. Why is the HP Compaq 8300 Difficult to modify Especially if you are upgrading from a hard drive.Īgain, here is the PCI adapter that I used: Upgrading the Dell Optiplex 7010 with PCI NVMe Solid State drive is a brilliant value upgrade, and completely transforms the machine. Now you can install an operating system of your choice or clone one of your existing drives to your new NVMe drive and enjoy a decent performance increase. This makes it marginally faster, but I doubt you would notice much difference. Untick all the SATA ports which do not have drives connected.įinally, if you want the maximum possible speed from your new drive, consider disabling C-States in the BIOS. You can fix this by going into the BIOS Setup and then System Configuration -> Drives. If you do not have any SATA drives connected you will receive a warning on start-up that says: Now that you have written the new BIOS, restart the machine. If possible use the Blue X16 PCI slot, it is much faster than smaller black one. If you have not yet installed your SSD into the machine, you can do it now. The BIOS modification is complete! Install the PCI NVMe SSD Shut down the machine and remove the jumper from the service pins and move it back to the password reset pins if you took it from there. Go back to your command prompt and run the command: Now go to File -> Save Image File and save the file in the same location as the flash tool as NVME.bin. Once those are out of the way, you can find it just above, and to the right of the RAM slots. If you are upgrading a Small Form Factor machine, the service jumper is in an awkward position which will require you to remove the Optical Drive and Hard Drive cage to access it. Locate the two pin service connector and put a jumper on it.Now that you have the machine prepared, you need to put the machine into service mode before you can proceed: Install the Required Drivers and Softwareīefore being able to read from or write to the BIOS, you need to install the Intel Management Engine Components from Dell.ĭownload the Intel Management Engine System Tools v8 r3, which contains the tools required to flash the new bios.Īlso download the NVME Driver which will be injected into the BIOS Image.įinally you will need UEFI Tool 0.28 to make the actual BIOS modification. Writing the modified BIOS back to the system.Adding NVMe driver support into the BIOS backup.Installing Required Software and drivers.Upgrade to the most recent BIOS from Dell:.This process involves the following steps: The procedure is slightly different depending on the model and form factor, but mostly the same. A Dell OptiPlex 3010, 7010 or 9010 to upgrade.An NVMe to PCIe Adapter, I used this one from Amazon. ![]() In order to carry out this upgrade, you will need a few things: Modify the BIOS and Inject the NVMe Driver.Install the Required Drivers and Software.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |